fci st50 series flow meters

  • fci st50 series flow meters

  • The lip seal of floating roof storage tank, fci st50 series flow meters relies on the sliding contact between elastic lip and tank wall. This kind of seal has strong applicability, but the requirements of manufacturing technology and material selection are high, and the determination of elastic seal also exists. The secondary seal of floating roof storage tank, fci st50 series flow meters is to add a seal on the basis of primary seal. It is proved by experiments that the secondary seal can reduce the liquid consumption by more than 50%, and has a more significant effect in safety.

  • [email protected]
  • Online Chating

Related searches fci st50 series flow meters

fci st50 flow meter, fci st50 series flow meters meter, fci thermal mass flow meter, fci st50 series flow meters control valve, fci flow meter st100,

ST50 Mass Flow Meter - Applied Measurement and Control Model ST50 is used for compressed air and nitrogen flow. Model ST51 is used for measuring biogas, digester gas, methane and natural gas. The ST50 Series utilizes FCI proven thermal dispersion technology to provide direct mass flow measurement resulting in higher performance at a lower cost than orifice plates, DP, Vortex shedding and other fci st50 series flow meters ST50 MASS FLOW METER Installation and Operation Guide ST50 MASS FLOW METER Installation and Operation Guide Recommended Straight Run To optimize flow meter system performance, FCI recommends installation with a minimum of 20 pipe diameters upstream straight run and 10 pipe diameters of downstream straight run. Where straight run limitations significantly reduce the available pipe diam-

ST50 - FCI Fluid Components International - PDF Catalogs fci st50 series flow meters

ST50 Flow Meter Single Insertion Point, Mass Flow Measurement With premium components and attention to detail FCIs ST50 series provides long-lasting flow meter quality and value. Its features and functions ensure application compatibility, maximum installation convenience, superior industrial durability and lowest maintenance. FCI ST50 Thermal Mass Flow Meter Series - Automation ST50 Series Flow Meters are an easily installed, no moving parts measurement solution for compressed air and nitrogen (ST50) and biogas, digester gas, methane and natural gas (ST51). They utilize FCIs proven thermal dispersion technology, providing direct mass flow measurement for higher performance at a lower cost than traditional technologies. FCI ST50 Series Flowmeters - appliedmc fci st50 series flow meters The ST50 Flowmeter is an accurate, easy to install, no moving parts solution for measuring and controlling air, compressed air or nitrogen flow. ST50 utilizes FCI proven thermal dispersion technology to provide direct mass flow measurement resulting in higher performance at a lower cost than orifice plates, DP, Vortex shedding and other thermal fci st50 series flow meters

FCI ST50 Series Flow Meters brochure - rawsonicd fci st50 series flow meters

ST50 Series Features Single Insertion Point, Mass Flow Measurement With premium components and attention to detail, FCIs ST50 series provides long-lasting flow meter quality and value. Its features and functions ensure application compatibility, maximum installation convenience, superior industrial durability and lowest maintenance.

Q345R material is a special steel grade for pressure vessels with a yield strength of 340MPa. It has good comprehensive mechanical properties and technological performance. The phosphorus and sulfur contents are slightly lower than the low-alloy high-strength steel plate Q345 (16Mn) steel. In addition to the increased tensile strength and elongation requirements compared to Q345 (16Mn) steel, it also requires impact toughness. Q345R steel plate is currently the most widely used and most used steel plate for pressure vessels in China.

Post Comments

Post Comments